linuswck commented on issue M-Labs/thermostat#92
Noisy measured TEC current (tec_i)Resolved: https://git.m-labs.hk/M-Labs/thermostat/pulls/105
linuswck closed issue M-Labs/thermostat#92
Noisy measured TEC current (tec_i)linuswck pushed to main at linuswck/INA848_INA849_Gain_Block
- 2992e608fd Finish rev0_1 design
linuswck pushed to main at linuswck/INA848_INA849_Gain_Block
- 3aa7711e9b Finish rev0_1 design
linuswck
renamed repository from INA848_Gain_Block
to linuswck/INA848_INA849_Gain_Block
linuswck created repository linuswck/INA848_INA849_Gain_Block
linuswck commented on issue sinara-hw/kirdy#17
[TEST] LD Driver Current Noise# DUT Specs 300pA/rt Hz current noise @ 1kHz 300nA RMS Noise (10Hz - 1MHz) # Measurement Equipment Keysight N9020a Noise Floor: ~9nV/sqrt(Hz) @ 1kHz (DC Coupling) (@100Hz Resolution)…
linuswck pushed to improve_adc_readings at linuswck/thermostat
- 8c1cb3117c README: Add notes on `i_tec` & `tec_i`readouts
linuswck created pull request M-Labs/thermostat#105
[WIP] Improve ADC Readings with Averaging Filterlinuswck pushed to improve_adc_readings at linuswck/thermostat
- 1fcfe41a63 Add averaging filter on the pin_adc readings
- 9fce19a418 Revert "Disable feedback current readout on flawed HW Revs"
- Compare 2 commits »
linuswck created repository linuswck/thermostat
linuswck pushed to master at M-Labs/kirdy
- e8aaf5f66b net: Implement iface polling timer
linuswck pushed to master at M-Labs/kirdy
- 4142519104 net: Implement iface polling timer
- 70fed23c51 main: Add checks before sock send/recv are called
- Compare 2 commits »
linuswck opened issue sinara-hw/kirdy#44
[TEST] Laser Diode Current Output Temperature Coefficientlinuswck commented on pull request M-Labs/thermostat#101
GUIConsider limiting the output current limit according to the specs([+-2A](https://github.com/sinara-hw/Thermostat/wiki)), I tried sourcing 3A into a TEC and Thermostat results in power failure. It…
linuswck commented on pull request M-Labs/thermostat#101
GUIWhen thermostat is autotuning and the connected device is disconnected, then it will end up in this interface. ![image](/attachments/867fb8b6-d72e-4101-b00c-2a2d1b31af82) The control panel…