915 B
915 B
Flashing the Firmware
Here are some extra steps needed for flashing the firmware.
Kasli
Windows
From the official manual:
On Windows, a third-party tool, Zadig, is necessary. Use it as follows:
- Make sure the FPGA board’s JTAG USB port is connected to your computer.
- Activate Options → List All Devices.
- Select the “Digilent Adept USB Device (Interface 0)” or “FTDI Quad-RS232 HS” (or similar) device from the drop-down list.
- Select WinUSB from the spinner list.
- Click “Install Driver” or “Replace Driver”.
- After above steps done, you may see the devices in the Device Manager:
You may need to repeat these steps every time you plug the FPGA board into a port where it has not been plugged into previously on the same system.