pounder_test/src/hardware/eeprom.rs

43 lines
1.5 KiB
Rust
Raw Normal View History

2021-04-13 18:28:05 +08:00
use embedded_hal::blocking::{delay::DelayMs, i2c::WriteRead};
2019-09-01 06:24:24 +08:00
2021-04-13 18:28:05 +08:00
// The EEPROM is a variant without address bits, so the 3 LSB of this word are "dont-cares".
2020-04-19 19:37:03 +08:00
const I2C_ADDR: u8 = 0x50;
2019-09-01 06:24:24 +08:00
2021-04-13 18:28:05 +08:00
// The MAC address is stored in the last 6 bytes of the 256 byte address space.
const MAC_POINTER: u8 = 0xFA;
pub fn read_eui48<T>(i2c: &mut T, delay: &mut impl DelayMs<u8>) -> [u8; 6]
2020-06-16 22:22:12 +08:00
where
T: WriteRead,
2020-04-19 19:37:03 +08:00
{
2021-04-13 18:28:05 +08:00
let mut previous_read: Option<[u8; 6]> = None;
// On Stabilizer v1.1 and earlier hardware, there is a fault where the I2C bus is not connected
// to the CPU until the P12V0A rail enables, which can take many seconds, or may never come up
// at all. During these transient turn-on conditions, we may fail the I2C read operation. To
// accomodate this, we repeat the I2C read for a set number of attempts with a fixed delay
// between them. Then, we wait for the bus to stabilize by waiting until the MAC address
// read-out is identical for two consecutive reads.
for _ in 0..40 {
let mut buffer = [0u8; 6];
if i2c
.write_read(I2C_ADDR, &[MAC_POINTER], &mut buffer)
.is_ok()
{
if let Some(old_read) = previous_read {
if old_read == buffer {
return buffer;
}
}
previous_read.replace(buffer);
} else {
// Remove any pending previous read if we failed the last attempt.
previous_read.take();
}
delay.delay_ms(100);
}
panic!("Failed to read MAC address");
2019-09-01 06:24:24 +08:00
}