renet
/
ENC424J600
10
1
Fork 1
Code Issues 3 Pull Requests 1 Projects Releases Wiki Activity

Update README

This commit is contained in:
Harry Ho 2020-06-24 16:18:22 +08:00
parent d399ebc3df
commit 03b7e65a93
1 changed files with 4 additions and 4 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

8
README.md
View File

@ -13,11 +13,11 @@ This program demonstrates the Ethernet TX capability on an STM32F407 board conne
* Source IP Address: 192.168.1.100
* Frame Length in Bytes: 64
This program assumes that **GPIO PA1** is connected to SPISEL of the Ethernet module. The program output is logged via ITM.
This program assumes that the **SPI1** port is connected to the Ethernet module, and the **GPIO PA1** pin is connected to its SPISEL pin. The program output is logged via ITM stimulus port 0.
#### How-to
1. On a console window, run OpenOCD and debug the example program:
1. Connect your STM32F407 device to the computer. Without changing any code, you may use an STLink V2 debugger. Then, on a console window, run OpenOCD and debug the example program:
```sh
$ nix-shell
[nix-shell]$ run-openocd-f4x
@ -58,11 +58,11 @@ This program demonstrates the TCP connectivity using **smoltcp** on an STM32F407
* This socket waits for a single incoming TCP packet on the said port, and sends a TCP packet holding a text of greeting on the port.
* Note that once a greeting is sent, the port is closed immediately. Further packets received by the controller are dropped until the initiator closes the port.
This program assumes that **GPIO PA1** is connected to SPISEL of the Ethernet module. The program output is logged via ITM.
This program assumes that the **SPI1** port is connected to the Ethernet module, and the **GPIO PA1** pin is connected to its SPISEL pin. The program output is logged via ITM stimulus port 0.
#### How-to
1. On a console window, run OpenOCD and debug the example program. Choose your own IPv4 address and prefix length:
1. Connect your STM32F407 device to the computer. Without changing any code, you may use an STLink V2 debugger. Then, on a console window, run OpenOCD and debug the example program. Choose your own IPv4 address and prefix length:
```sh
$ nix-shell
[nix-shell]$ run-openocd-f4x