1
0
Fork 0

Update windows drivers instructions

Signed-off-by: Egor Savkin <es@m-labs.hk>
This commit is contained in:
Egor Savkin 2023-08-02 12:08:48 +08:00
parent 4d6d43299a
commit e2ea70955c
4 changed files with 8 additions and 1 deletions

Binary file not shown.

After

Width:  |  Height:  |  Size: 21 KiB

Binary file not shown.

After

Width:  |  Height:  |  Size: 18 KiB

View File

@ -14,5 +14,7 @@ On Windows, a third-party tool, Zadig, is necessary. Use it as follows:
3. Select the “Digilent Adept USB Device (Interface 0)” or “FTDI Quad-RS232 HS” (or similar) device from the drop-down list.
4. Select WinUSB from the spinner list.
5. Click “Install Driver” or “Replace Driver”.
6. After above steps done, you may see the devices in the Device Manager:
![after_zadig_devices.png](../img/win32/after_zadig_devices.png)
You may need to repeat these steps every time you plug the FPGA board into a port where it has not been plugged into previously on the same system.

View File

@ -26,7 +26,9 @@ until its fully loaded.
Use following instructions to set correct drivers for the COM ports.
At choosing FTDI drivers stage you may have longer list of drivers.
In that case, choose respective `USB Serial Converter X` (A for 0, B for 1, C for 2, D for 3) driver.
In that case, choose respective `USB Serial Converter X` (A for 0, B for 1, C for 2, D for 3) driver. In case you cannot
locate the devices, they may appear in the _Other devices_ section:
![other_devices_section.png](../img/win32/other_devices_section.png)
You may also need to reboot your PC after doing this.
1. ![com_driver_set0.png](../img/win32/com_driver_set0.png)
@ -37,6 +39,9 @@ You may also need to reboot your PC after doing this.
6. ![com_driver_set5.png](../img/win32/com_driver_set5.png)
7. ![com_driver_set6.png](../img/win32/com_driver_set6.png)
If you are here after [flashing firmware](flashing_firmware.md) stage, you may fail to see the devices in the described locations.
If you see them in the `Universal Serial Bus devices` section, you may need just to uninstall the third _Quad_ device and reconnect the
Kasli/Kasli-SoC to the PC.
#### Connecting with PuTTY