1
0
Fork 0

Add sections about flashing the firmware and moninj

Signed-off-by: Egor Savkin <es@m-labs.hk>
This commit is contained in:
Egor Savkin 2023-07-13 12:23:48 +08:00
parent 097f4e8cec
commit c6cb876c1c
3 changed files with 31 additions and 0 deletions

View File

@ -20,3 +20,5 @@
- [Software/Support](./sw_sup/software_support.md) - [Software/Support](./sw_sup/software_support.md)
- [Networking](./sw_sup/networking.md) - [Networking](./sw_sup/networking.md)
- [UART Logs](./sw_sup/uart_logs.md) - [UART Logs](./sw_sup/uart_logs.md)
- [Flashing the Firmware](./sw_sup/flashing_firmware.md)
- [Moninj](./sw_sup/moninj.md)

View File

@ -0,0 +1,18 @@
# Flashing the Firmware
Here are some extra steps needed for flashing the firmware.
## Kasli
### Windows
From the [official manual](https://m-labs.hk/artiq/manual/installing.html#configuring-openocd):
On Windows, a third-party tool, Zadig, is necessary. Use it as follows:
1. Make sure the FPGA boards JTAG USB port is connected to your computer.
2. Activate Options → List All Devices.
3. Select the “Digilent Adept USB Device (Interface 0)” or “FTDI Quad-RS232 HS” (or similar) device from the drop-down list.
4. Select WinUSB from the spinner list.
5. Click “Install Driver” or “Replace Driver”.
You may need to repeat these steps every time you plug the FPGA board into a port where it has not been plugged into previously on the same system.

11
src/sw_sup/moninj.md Normal file
View File

@ -0,0 +1,11 @@
# Moninj
The official documentation lacks the description of MONitor/INJector, but it is a common mistake when running the ARTIQ-7.
Basically it is a service that consists of two parts - one runs on the host PC, another on the Kasli.
It allows to watch and control the state of the devices, so you can see it on the dashboard.
That's why the dashboard may emit errors about not working moninj. To fix this, you just need [to run it with Kasli's IP](https://m-labs.hk/artiq/manual/utilities.html#moninj-proxy):
```shell
aqctl_moninj_proxy CORE_ADDRESS
```