diff --git a/README.md b/README.md
index 8ee69f2..4244484 100644
--- a/README.md
+++ b/README.md
@@ -22,7 +22,7 @@
 ## Limitations/TODOs
 
 * Fixed AFE gains
-* The IP and MAC address are [hardcoded](src/main.rs)
+* The IP and MAC address are [hardcoded](src/hardware/configuration.rs)
 * Expose configurable limits
 * 100Base-T only
 * Digital IO, GPIO header, AFE header, EEM header are not handled
@@ -64,14 +64,14 @@ See https://github.com/sinara-hw/Stabilizer
 * Install the DFU USB tool (`dfu-util`)
 * Connect to the Micro USB connector below the RJ45
 * Short JC2/BOOT
-* `cargo objcopy --release --bin stabilizer -- -O binary stabilizer.bin` or `arm-none-eabi-objcopy -O binary target/thumbv7em-none-eabihf/release/stabilizer stabilizer.bin`
-* `dfu-util -a 0 -s 0x08000000:leave -D stabilizer.bin`
+* `cargo objcopy --release --bin dual-iir -- -O binary dual-iir.bin` or `arm-none-eabi-objcopy -O binary target/thumbv7em-none-eabihf/release/dual-iir dual-iir.bin`
+* `dfu-util -a 0 -s 0x08000000:leave -D dual-iir.bin`
 
 ### Using ST-Link virtual mass storage
 
-* `cargo objcopy --release --bin stabilizer -- -O binary stabilizer.bin` or `arm-none-eabi-objcopy -O binary target/thumbv7em-none-eabihf/release/stabilizer stabilizer.bin`
+* `cargo objcopy --release --bin dual-iir -- -O binary dual-iir.bin` or `arm-none-eabi-objcopy -O binary target/thumbv7em-none-eabihf/release/dual-iir dual-iir.bin`
 * Connect the ST-Link debugger
-* copy `stabilizer.bin` to the `NODE_H743ZI` USB disk
+* copy `dual-iir.bin` to the `NODE_H743ZI` USB disk
 
 ## Protocol