assembly/src/hw/suservo.md

SUServo (Sampler + Urukul)

JSON

{
  "type": "suservo",
  "sampler_ports": [<port num>, <port num>],
  "urukul0_ports": [<port num>, <port num>],
  "urukul1_ports": [<port num>, <port num>], // optional
  "clk_sel": 2
}

With enabled SUServo mode, you only need to add suservo to JSON file, with its Sampler and Urukul(s) removed.

Setup

On bottoms of each Urukul, switch first pins 1 and 2 to ON, as on the picture:

Testing

After running artiq_sinara_test:

*** Testing SUServos.
Initializing modules...
suservo0
...done
Setting up SUServo channels...
suservo0_ch0
suservo0_ch1
suservo0_ch2
suservo0_ch3
suservo0_ch4
suservo0_ch5
suservo0_ch6
suservo0_ch7
...done
Enabling...
suservo0
...done
Each Sampler channel applies proportional amplitude control
on the respective Urukul0 (ADC 0-3) and Urukul1 (ADC 4-7, if
present) channels.
Frequency: 10 MHz, output power: about -9 dBm at 0 V and about -15 dBm at 1.5 V
Verify frequency and power behavior.

1. Connect oscilloscope to the urukul0 port and configure with time and voltage scale and trigger threshold so that you'll see sine wave, like on the picture:
2. Verify amplitude and frequency
3. Apply 1.5V (connect the AA-battery) to the sampler0 port, as on the picture:
4. You should see significant amplitude decrease, as in the picture:
5. Verify amplitude difference, and the frequency to be unchanged
6. Repeat steps 1-5 for every available channel.