thermostat/src/main.rs

290 lines
9.8 KiB
Rust

#![cfg_attr(not(test), no_std)]
#![cfg_attr(not(test), no_main)]
#![cfg_attr(test, allow(unused))]
// TODO: #![deny(warnings, unused)]
#[cfg(not(any(feature = "semihosting", test)))]
use panic_halt as _;
#[cfg(all(feature = "semihosting", not(test)))]
use panic_semihosting as _;
use log::{error, info, warn};
use cortex_m::asm::wfi;
use cortex_m_rt::entry;
use stm32f4xx_hal::{
hal::watchdog::{WatchdogEnable, Watchdog},
rcc::RccExt,
stm32::{CorePeripherals, Peripherals, SCB},
time::{U32Ext, MegaHertz},
watchdog::IndependentWatchdog,
};
use smoltcp::{
time::Instant,
socket::TcpSocket,
wire::EthernetAddress,
};
mod init_log;
use init_log::init_log;
mod usb;
mod leds;
mod pins;
use pins::Pins;
mod ad7172;
mod ad5680;
mod net;
mod server;
use server::Server;
mod session;
use session::{Session, SessionInput};
mod command_parser;
use command_parser::Ipv4Config;
mod timer;
mod pid;
mod steinhart_hart;
mod channels;
use channels::{CHANNELS, Channels};
mod channel;
mod channel_state;
mod config;
use config::ChannelConfig;
mod flash_store;
mod dfu;
mod command_handler;
use command_handler::Handler;
mod fan_ctrl;
use fan_ctrl::FanCtrl;
mod hw_rev;
const HSE: MegaHertz = MegaHertz(8);
#[cfg(not(feature = "semihosting"))]
const WATCHDOG_INTERVAL: u32 = 1_000;
#[cfg(feature = "semihosting")]
const WATCHDOG_INTERVAL: u32 = 30_000;
const CHANNEL_CONFIG_KEY: [&str; 2] = ["ch0", "ch1"];
const TCP_PORT: u16 = 23;
fn send_line(socket: &mut TcpSocket, data: &[u8]) -> bool {
let send_free = socket.send_capacity() - socket.send_queue();
if data.len() > send_free + 1 {
// Not enough buffer space, skip report for now,
// instead of sending incomplete line
warn!(
"TCP socket has only {}/{} needed {}",
send_free + 1, socket.send_capacity(), data.len(),
);
} else {
match socket.send_slice(&data) {
Ok(sent) if sent == data.len() => {
let _ = socket.send_slice(b"\n");
// success
return true
}
Ok(sent) =>
warn!("sent only {}/{} bytes", sent, data.len()),
Err(e) =>
error!("error sending line: {:?}", e),
}
}
// not success
false
}
/// Initialization and main loop
#[cfg(not(test))]
#[entry]
fn main() -> ! {
init_log();
info!("thermostat");
let mut cp = CorePeripherals::take().unwrap();
cp.SCB.enable_icache();
cp.SCB.enable_dcache(&mut cp.CPUID);
let dp = Peripherals::take().unwrap();
let clocks = dp.RCC.constrain()
.cfgr
.use_hse(HSE)
.sysclk(168.mhz())
.hclk(168.mhz())
.pclk1(32.mhz())
.pclk2(64.mhz())
.freeze();
let mut wd = IndependentWatchdog::new(dp.IWDG);
wd.start(WATCHDOG_INTERVAL.ms());
wd.feed();
timer::setup(cp.SYST, clocks);
let (pins, mut leds, mut eeprom, eth_pins, usb, fan, hwrev, hw_settings) = Pins::setup(
clocks, dp.TIM1, dp.TIM3, dp.TIM8,
dp.GPIOA, dp.GPIOB, dp.GPIOC, dp.GPIOD, dp.GPIOE, dp.GPIOF, dp.GPIOG,
dp.I2C1,
dp.SPI2, dp.SPI4, dp.SPI5,
dp.ADC1,
dp.OTG_FS_GLOBAL,
dp.OTG_FS_DEVICE,
dp.OTG_FS_PWRCLK,
);
leds.r1.on();
leds.g3.off();
leds.g4.off();
usb::State::setup(usb);
let mut store = flash_store::store(dp.FLASH);
let mut channels = Channels::new(pins);
for c in 0..CHANNELS {
match store.read_value::<ChannelConfig>(CHANNEL_CONFIG_KEY[c]) {
Ok(Some(config)) =>
config.apply(&mut channels, c),
Ok(None) =>
error!("flash config not found for channel {}", c),
Err(e) =>
error!("unable to load config {} from flash: {:?}", c, e),
}
}
let mut fan_ctrl = FanCtrl::new(fan, hw_settings);
// default net config:
let mut ipv4_config = Ipv4Config {
address: [192, 168, 1, 26],
mask_len: 24,
gateway: None,
};
match store.read_value("ipv4") {
Ok(Some(config)) =>
ipv4_config = config,
Ok(None) => {}
Err(e) =>
error!("cannot read ipv4 config: {:?}", e),
}
// EEPROM ships with a read-only EUI-48 identifier
let mut eui48 = [0; 6];
eeprom.read_data(0xFA, &mut eui48).unwrap();
let hwaddr = EthernetAddress(eui48);
info!("EEPROM MAC address: {}", hwaddr);
net::run(clocks, dp.ETHERNET_MAC, dp.ETHERNET_DMA, eth_pins, hwaddr, ipv4_config.clone(), |iface| {
Server::<Session>::run(iface, |server| {
leds.r1.off();
let mut should_reset = false;
loop {
let mut new_ipv4_config = None;
let instant = Instant::from_millis(i64::from(timer::now()));
let updated_channel = channels.poll_adc(instant);
if let Some(channel) = updated_channel {
server.for_each(|_, session| session.set_report_pending(channel.into()));
}
fan_ctrl.cycle(channels.current_abs_max_tec_i());
if channels.pid_engaged() {
leds.g3.on();
} else {
leds.g3.off();
}
let instant = Instant::from_millis(i64::from(timer::now()));
cortex_m::interrupt::free(net::clear_pending);
server.poll(instant)
.unwrap_or_else(|e| {
warn!("poll: {:?}", e);
});
if ! should_reset {
// TCP protocol handling
server.for_each(|mut socket, session| {
if ! socket.is_active() {
let _ = socket.listen(TCP_PORT);
session.reset();
} else if socket.may_send() && !socket.may_recv() {
socket.close()
} else if socket.can_send() && socket.can_recv() {
match socket.recv(|buf| session.feed(buf)) {
// SessionInput::Nothing happens when the line reader parses a string of characters that is not
// followed by a newline character. Could be due to partial commands not terminated with newline,
// socket RX ring buffer wraps around, or when the command is sent as seperate TCP packets etc.
// Do nothing and feed more data to the line reader in the next loop cycle.
Ok(SessionInput::Nothing) => {}
Ok(SessionInput::Command(command)) => {
match Handler::handle_command(command, &mut socket, &mut channels, session, &mut store, &mut ipv4_config, &mut fan_ctrl, hwrev) {
Ok(Handler::NewIPV4(ip)) => new_ipv4_config = Some(ip),
Ok(Handler::Handled) => {},
Ok(Handler::CloseSocket) => socket.close(),
Ok(Handler::Reset) => should_reset = true,
Err(_) => {},
}
}
Ok(SessionInput::Error(e)) => {
error!("session input: {:?}", e);
send_line(&mut socket, b"{ \"error\": \"invalid input\" }");
}
Err(_) =>
socket.close(),
}
} else if socket.can_send() {
if let Some(channel) = session.is_report_pending() {
match channels.reports_json() {
Ok(buf) => {
send_line(&mut socket, &buf[..]);
session.mark_report_sent(channel);
}
Err(e) => {
error!("unable to serialize report: {:?}", e);
}
}
}
}
});
} else {
// Should reset, close all TCP sockets.
let mut any_socket_alive = false;
server.for_each(|mut socket, _| {
if socket.is_active() {
socket.abort();
any_socket_alive = true;
}
});
// Must let loop run for one more cycle to poll server for RST to be sent,
// this makes sure system does not reset right after socket.abort() is called.
if !any_socket_alive {
SCB::sys_reset();
}
}
// Apply new IPv4 address/gateway
new_ipv4_config.take()
.map(|config| {
server.set_ipv4_config(config.clone());
ipv4_config = config;
});
// Update watchdog
wd.feed();
leds.g4.off();
cortex_m::interrupt::free(|cs| {
if !net::is_pending(cs) {
// Wait for interrupts
// (Ethernet, SysTick, or USB)
wfi();
}
});
leds.g4.on();
}
});
});
unreachable!()
}